by edward | Feb 12, 2015 | Exchange 2010
If you are installing a new Exchange 2010 Server or want to update the existing servers Autodiscover and EWS URL’s then follow the commands below. EWS (Exchange WEB Services) To check what the URL is currently run the following command from the Exchange...
by edward | Feb 9, 2015 | Exchange 2010
Error: The following error was generated when “$error.Clear(); Set-WERRegistryMarkers; ” was run: “Provisioning layer initialization failed: ‘Failed to reconnect to Active Directory server <DC>. Make sure the server is available, and that...
by edward | Feb 9, 2015 | Exchange 2010
Error: Exchange 2010 SP3 installation hangs on languages installation. Solution: Upgrading to Exchange 2010 SP3 starts out fine. Later on during the installation when the task to install language just hangs and the progress bar doesn’t move at all. As this...
by edward | Feb 5, 2015 | Exchange 2010
This small guide shows you how to open the Queue Viewer from the Exchange Toolbox and to check the email queues in Exchange 2010: Open up the Exchange Management Console. Exchange Microsoft Exchange On-Premises. Step 1 -> Click on Toolbox. Step 2 -> Double click...
by edward | Feb 5, 2015 | Exchange 2010
On event viewer you might see Event ID 531 – ESE – Data corruption: Solution: Open up iSCSI and find where that DB is connected and then click the Connect button again. This will refresh the connection. All alerts should stop after that. Otherwise check...
